Apex Destiny 6100 Support

What should I do if my Apex Destiny 6100 security system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. SILENCING STATUS TONES/BEEPING During a ‘trouble’ situation, (such as loss of phone line, low battery) the system will emit a tone or beep to notify you that there is a problem. To stop this beeping simply press the STATUS key. Contact your alarm […]

How do I add or change user codes on Apex Destiny 6100 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. CHANGING/DELETING USER CODES The Destiny allows 32 different disarm codes. Check with your installer to find out how many codes you have enabled. Assuming your primary code is 1,2,3,4: 1. Enter your primary user code followed by “7”. Example: 1,2,3,4,7. 2. The system […]

How do I arm and disarm my Apex Destiny 6100 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. ARMING When referring to the operation of the phone, the following instructions will assume that access to the system has already taken place. (See local and remote phone access) Remember, your installer has programmed a one to four digit code which you will […]

How do I bypass zones on my Apex Destiny 6100 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. BYPASS To BYPASS a zone is to temporarily remove that zone from the system. To enter BYPASS mode, your system must be disarmed. Make sure the system is disarmed and follow the steps below: 1. Enter your disarm code and immediately press the […]

Why is my Apex Destiny 6100 security system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. POWER On when AC or back-up battery power is present. If AC power is lost, the STATUS LED will flash, the system will speak “POWER OFF” one time, and the system will emit a trouble beep every few seconds until the power is […]