DSC Envoy Support

What should I do if my DSC Envoy system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. From time to time, the batteries in the detectors and other components on your system will need to be changed. If a device has a low battery, your system will announce a “Device Low Battery” trouble message. Press [7], and the system will […]

How to add or change user codes for DSC Envoy system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Programming Access Codes The master code (code 40) can be used to program system options, arm and disarm the system and program other access codes. You can program up to 32 additional access codes (01 through 32). Other access codes, such as system […]

How do I arm and disarm my DSC Envoy system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Turning On Your System 1. Before you turn on your system, make sure that it is Ready. You can tell that the system is ready when the green (Ready) light is ON. If the green light is not on, see the Note below. […]

How do I bypass zones on my DSC Envoy alarm system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Turning Off Part of Your System (Bypassing Zones) Sometimes, you may need to temporarily turn off a detector: • if you need to go into a protected area while the system is turned on • or, if a detector is temporarily out of […]

Why is my DSC Envoy alarm system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Checking Trouble Conditions Your system continuously checks for a number of possible trouble conditions. If one of these trouble conditions occur: • the yellow (System) light will be ON until the trouble is fixed • the keypad will beep twice every 10 seconds […]