DSC PC1550 & 1500 Support

What should I do if my DSC PC1550 or 1500 system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Viewing Trouble Conditions The PC1500/1550 continuously monitors a number of possible trouble conditions. If one of these trouble conditions occur, the keypad will beep twice every 10 seconds and the keypad “Trouble” indicator will light. Pressing any key on the keypad will silence […]

How do I bypass zones on my DSC PC1550 or 1500 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Zone Bypassing Use zone bypassing when access is needed to part of the protected area while the system is armed. Bypassed zones will not cause an alarm. Zones that are temporarily out of service due to damaged wiring or contacts may be bypassed […]

How do I add or change user codes for DSC PC1550 or 1500 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. The Master Code Enter [*][5][current Master Code][1][new Master Code]. Press [#] to return to Ready. Additional Codes Up to 5 additional access codes (2 through 6) may be programmed. The 6th access code may be established by your installer as a One-Time use […]

How do I arm and disarm my DSC PC1550 or 1500 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Arming the System Check the following items before arming the system: Bypass Light If the “Bypass” light is ON, insure that zones are intentionally bypassed before arming the system (See Zone Bypassing section). Trouble Light If the “ Trouble” light is ON, check […]

Why is my DSC PC 1550 or 1500 system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Viewing Trouble Conditions The PC1500/1550 continuously monitors a number of possible trouble conditions. If one of these trouble conditions occur, the keypad will beep twice every 10 seconds and the keypad “Trouble” indicator will light. Pressing any key on the keypad will silence […]