DSC PC1000 Support

What should I do if my DSC PC1000 system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Trouble Display The control panel continuously monitors a number of possible trouble conditions. If one of these conditions occurs, the keypad sounder will beep and the keypad “System” indicator will come ON. Press the [*] then [2] keys to display the type of […]

How do I add or change user codes for DSC PC1000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Programming additional access codes Programming additional access codes can only be done with the Master Code. To program a new access code, enter [*] [5] and [Master Code]. Zone light 1 will be ON to indicate that the Master Code is already programmed. […]

How do I bypass zones on my DSC PC1000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Zone Bypassing Bypassed zones do not cause an alarm. Use zone bypassing when access is needed to part of the protected area. Also, damaged wiring or contacts on a zone may be temporarily bypassed until repairs can be made so that the panel […]

How do I arm and disarm my DSC PC1000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Arming To arm the system, first close all protected doors and windows and stop movement in areas covered by motion detectors. Check to see that the “Ready” light is ON (all zones are closed). The system cannot be armed unless the “Ready” light […]

Why is my DSC PC1000 system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. TROUBLE DISPLAY The control panel continuously monitors a number of possible trouble conditions. If one of these conditions occurs, the keypad sounder will beep and the keypad “System” indicator will come ON. Press the [*] then [2] keys to display the type of […]