THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. TROUBLE DISPLAY The PC2000 continuously monitors a number of possible trouble conditions. If one of these conditions occurs, the keypad ‘TROUBLE’ indicator will light. Press the [*] then [2] keys to display the type of trouble. The ‘ZONE’ lights indicate the type of […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. PROGRAMMING ADDITIONAL SECURITY CODES Enter [*],[5] and [master security code]. The ‘PROGRAM’ light will flash and the ‘ZONE’ lights will show which codes have already been programmed (up to 8 codes can be programmed from the keypad). Press any key from (1 to […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. ZONE BY-PASSING (SHUNTING) Shunted zones do not cause an alarm. Use zone shunting when access is needed to part of the protected area. Also, damaged wiring or contacts on a zone may be temporarily shunted until repairs can be made so that the […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. ARMING Close all protected doors and windows and stop movement in areas covered by motion detectors. If ‘SHUNT’ light is on, be sure zones are being intentionally by-passed before arming the system (see ZONE BY-PASSING). Check to see that the ‘READY’ light is […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. TROUBLE DISPLAY The PC2000 continuously monitors a number of possible trouble conditions. If one of these conditions occurs, the keypad ‘TROUBLE’ indicator will light. Press the [*] then [2] keys to display the type of trouble. The ‘ZONE’ lights indicate the type of […]