DSC PC3000 Support

What should I do if my DSC PC3000 system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Maintenance It is recommended that the back-up battery be replaced every three years. Contact your installing company for information on replacing the battery. To display the trouble conditions, enter [*] [2]. Trouble conditions are represented with the Zone Lights; if a Zone Light […]

How do I bypass zones on my DSC PC3000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. ZONE BYPASSING Bypassed zones do not cause an alarm. Use zone bypassing when access is needed to part of the protected area. Also, damaged wiring or contacts on a zone may be temporarily bypassed until repairs can be made so that the panel […]

How do I arm and disarm my DSC PC3000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. ARMING Close all protected doors and windows and stop movement in areas covered by motion detectors. If the “Bypass” light is ON, be sure zones are being intentionally bypassed before arming the system (see Zone Bypassing). Check to see that the “Ready” light […]

How do I add or change user codes for DSC PC3000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. PROGRAMMING ADDITIONAL ACCESS CODES Up to 15 access codes in addition to the Master Code can be entered from the keypad. Enter [*][5][Master Code]. The “Program” light will flash and the zone lights will show which codes have already been programmed. To enter […]

Why is my DSC PC3000 system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. TROUBLE DISPLAY The PC3000 continuously monitors a number of possible trouble conditions. If one of these conditions occurs, the keypad sounder will beep quickly twice every 10 seconds and the keypad “Trouble” indicator will light. Pressing any key on the keypad will silence […]