DSC PC4010 Support

How do I arm and disarm my DSC PC4010 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. ARMING Close all protected doors and windows and stop movement in areas covered by motion detectors. The “Enter Code to Arm System” message should be on the LCD display. The system cannot be armed unless the “Enter Code to Arm System” or “Secure […]

How do I add or change user codes for DSC PC4010 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. USER PROGRAMMING COMMANDS [*]+[5]+[ACCESS CODE] The [*] [5] [Access Code] command is used to program the Master Codes and regular access codes. The first access code is the System Grand Master Code. Normally, only the installer can change the System Grand Master Code. […]

How do I bypass zones on my DSC PC4010 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. ZONE BYPASSING [*]+[1] A bypassed zone will not cause an alarm. If a zone is bypassed the panel may be armed even if the zone is open. Use zone bypassing when access is needed to part of the protected area. Also, damaged wiring […]

What should I do if my DSC PC4010 system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. To display the trouble conditions, enter [*] [2]. Battery Trouble A battery trouble will be displayed and can be reported if the battery is 11.3 volts or less, disconnected or the battery fuse fails. Battery voltage is checked once every 4 minutes, so […]

Why is my DSC PC4010 system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. TROUBLE DISPLAY [✱]+[2] The PC4010 continuously monitors a number of possible trouble conditions. If one of these conditions occurs, the keypad “TROUBLE” indicator will light and the audible indication will sound (two short beeps every 10 seconds). When the [#] key is pressed […]