THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM Replacing Batteries From time to time, the batteries in the detectors and other components on your system will need to be changed. If a device has a low battery, your system will announce a “Device Low Battery” trouble message (see Checking Trouble Conditions […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM Programming Access Codes The master code (code 40) can be used to program system  options, arm  and dis- arm the system and program other access codes. You can program up to 32 additional access codes (01 through 32). Other access  codes,  such  as  […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM Turning Off Part of Your System (Bypassing Zones) Sometimes, you may need to temporarily turn off a detector: if you need to go into a protected area while the system is turned on or, if a detector is temporarily out of service but […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Turning On Your System Before you turn on your system, make sure that it is You can tell that the system is ready when the green (Ready) light is ON. If the green light is not on, see the Note below. Enter your […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Checking Trouble Conditions Your system continuously checks for a number of possible trouble conditions. If one of these trouble conditions occur: • the yellow (System) light will be ON until the trouble is fixed • the keypad will beep twice every 10 seconds […]