DSC Power 832 Support

What should I do if my DSC Power 832 system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM It is recommended that the back-up battery be replaced every three years. Contact your installing company for information on replacing the battery. Troubles on an LED Keypad: To display the trouble conditions, enter [*] [2]. Trouble conditions are represented with the Zone Lights; […]

How do I bypass zones on my DSC Power 832 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM To bypass zones from an LED keypad: Start with the system in the Ready state. Enter [*][1][Zone number(s) to be bypassed]. Enter the zone number(s) as a double digit from 01 to 32. As each zone is bypassed, the corresponding zone light will […]

How do I add or change user codes for DSC Power 832 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM Programming Security Codes Programming codes from an LED Keypad: To program the Master Code, enter [*][5][current Master Code][40][new Master Code]. The Master Code must be four digits unless otherwise indicated by your installer. Enter digits 0 through 9 only. Press [#] to return […]

How do I arm or disarm my DSC Power 832 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM Arming the System Arming from an LED Keypad: If the Ready light is ON, the system is ready for arming. If the Ready light is OFF, check to see that all doors and windows are closed and that motion is stopped in areas […]

Why is my DSC Power 832 system beeping?

Viewing Trouble Conditions The control panel continuously monitors a number of possible trouble conditions. If one of these trouble conditions occur, the keypad will beep twice every 10 seconds until you press any key on the keypad. NOTE: A TROUBLE condition reduces the security your system is designed to provide. Call your installing company for […]