Honeywell Ademco Lynx Plus L3000 Support

How do I add or change user codes for Ademco Lynx Plus L3000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. To Add/Delete a User or Change a User’s Code Changing the Master User Code: Follow the procedure for changing codes but use user 02 and enter the new code twice. Master code is always user 02. Add a user Code: Enter [Master user […]

How do I bypass zones on my Ademco Lynx Plus L3000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Bypassing Individual Zones To bypass a zone(s): Enter [user code] + [BYPASS] + 2 digit zone number(s) to be bypassed (e.g., 01, 02, 03 etc.). The keypad will provide a confirmation beep and display the word “Bypass” along with each bypassed zone number. […]

How do I arm and disarm my Ademco Lynx Plus L3000 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Arming the System To arm in STAY mode: Enter your [user code] + [STAY]. The keypad beeps three times and displays the “Armed STAY” message. the red ARMED indicator lights and the system announces “Armed STAY-Exit now”. To arm in AWAY mode: Enter […]

What should I do if my Ademco Lynx Plus L3000 system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Low Battery Conditions in Wireless Sensors Each wireless sensor in your system has a 9-volt or 3-volt battery. The system detects low battery conditions in wireless sensors, including smoke detectors, personal emergency transmitter, and the portable wireless keypad, and displays a “Low Bat” […]

Why is my Ademco Lynx Plus L3000 system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Typical Trouble Condition Displays To silence the beeping sound for fault conditions, press any key. Fault: Indicates that a problem exists with the zone(s) displayed, accompanied by rapid beeping. First, determine if the zone(s) displayed are intact and make them so if they […]