Honeywell Vista 128FPB Support

How do I arm and disarm my Honeywell Vista 128FPB system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Arming¬† Perimeter Only Enter your security code and press [3] for stay command. Keypad will beep three times and will display the armed message, “ARMED ***STAY*** ZONE BYPASSED”. Note: “ZONE BYPASSED” in this display simply indicates that the interior zones of protection are […]

How do I bypass zones on my Honeywell Vista 128FPB system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. To bypass zones, the system must be disarmed first. BYPASS Enter your security code and press [6] (BYPASS). Enter zone number(s) for the zones to be bypassed (e.g., 001, 002, 003, etc.). Important! All single-digit numbers must be preceded by “00 ” (for […]

How do I add or change user codes for Honeywell Vista 128FPB system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. To Add a User IMPORTANT: Temporary users should not be shown how to use any system function they do not need to know (e.g. bypassing protection zones). Enter Master or Manager code and press the [8] key. Enter the new user’s 3-digit User […]

What should I do if my Honeywell Vista 128FPB system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Trouble Conditions Power Failure If the POWER indicator is off, operating power for the system has stopped and is inoperative. CALL FOR SERVICE IMMEDIATELY. If the POWER indicator is on, but the message “AC LOSS” is displayed, the Keypad is operating on battery […]

Why is my Honeywell Vista 128FPB system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Trouble Conditions Typical Trouble Displays The word CHECK or TRBL on the Keypad’s display, accompanied by a rapid “beeping” at the Keypad, indicates that there is a trouble condition in the system. To silence the beeping sound for trouble conditions, press any key. […]