Honeywell Vista 20P Support

What should I do if my Honeywell Vista 20p system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Trouble Conditions * Any “beeping” that accompanies a trouble display can be stopped by depressing any key on the keypad or by entering an OFF sequence (code + OFF) “SYSTEM LO BAT” Indicates that a low system battery (or BAT with no condition […]

How do I add or change user codes for Honeywell Vista 20p system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. How to Assign User Codes Add User Code: System/Partition Master code + [8] + user no. + new user’s code. The Keypad beeps once to confirm that new user was added. (Users 03/33 are preset  to partition programmers, but can be changed.) Note: […]

How do I bypass zones on my Honeywell Vista 20p system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Using the BYPASS Key When bypassing zones: • The system must be disarmed before you can bypass zones. • Bypassed zones are unprotected and will not cause an alarm if violated. • The system will not allow fire zones to be bypassed. • […]

How do I arm and disarm my Honeywell Vista 20p system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Arming Commands Before arming, close all perimeter doors and windows and make sure the Ready to Arm message is displayed. ARM STAY —- security code + 3 STAY — the system will sound three beeps, armed STAY message displayed, red ARMED indicator lights […]

Why is my Honeywell Vista 20P system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Trouble Conditions “Check” and “Battery” Displays The word CHECK on the keypad’s display, accompanied by a “beeping” at the keypad, indicates a trouble condition in the system. To silence the beeping for these conditions, press any key. 1. A display of “CHECK” and […]

Why is my Honeywell Vista 20P or 15P system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Trouble Conditions “Check” and “Battery” Displays The word CHECK on the keypad’s display, accompanied by a “beeping” at the keypad, indicates a trouble condition in the system. To silence the beeping for these conditions, press any key. 1. A display of “CHECK” and […]