Moose Z1100e Support

How do I arm and disarm my Moose Z1100e system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Arming the Control Prior to Leaving Verify the READY TO ARM light is on. Press the ARM command [1] then your personal authorization code (PAC) The control station will begin beeping and the red ARMED light will light to indicate the system is […]

What should I do if my Moose Z1100e system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Power Light Blinking: If the POWER light is blinking and the control station is beeping, the system battery is weak or an internal fuse is blown. The [*] key may be pressed to silence the control station. Extended power outages will discharge the […]

How do I bypass zones on my Moose Z1100e system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Zone Bypassing (Shunting) To Shunt (Bypass) a Zone: The system must be disarmed. Press the SHUNT command [#] then press two digits, 01-16 corresponding to the zone to be bypassed. (Be sure to enter all zones as two digits: 01, 02…. etc.) The […]

How do I add or change user codes for Moose Z1100e system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Programming User Codes System must be disarmed. Press the PROGRAM command [9] then enter the MASTER PROGRAMMING CODE. The control station will emit two beeps and all indicator lights will blink when programming mode is successfully entered. Press the number corresponding to the […]

Why is my Moose Z1100e system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Diagnosing A Problem Zone Status Display The zone status command is used to identify which zones are opened or bypassed (shunted). This is useful prior to arming the system when the ready light is off or blinking. The control station lights become indicators […]