Napco Gem P801 Support

What should I do if my Napco Gem P801 system has a low battery?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. SYSTEM TROUBLES To determine the nature of the trouble, press [FUNCTION] KEY followed by [4], count the number of keypad beeps and observe the number of the illuminated zone. Refer to the following table to determine the cause of the trouble. If there […]

How do I add or change user codes for Napco Gem P801 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Entering the User Program Mode Press [FUNCTION] key followed by [8A] and enter the User 1 code followed by [on/off] key. The Armed, Status and Trouble lights will flash, and the keypad will beep 4 times. You are now in the User Program […]

How do I bypass zones on my Napco Gem P801 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Bypassing Zones If an open zone cannot be immediately fixed it can be left unprotected, or bypassed ,while the rest of the system is Armed. To bypass a zone: 1. Press [bypass] key followed by the number of the zone to be bypassed. […]

How do I arm and disarm my Napco Gem P801 system?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Arming Your System When Leaving Before arming your system, make sure the green Status light is ON. This indicates that all of your protective zones are secure. If any zones are open, the corresponding Zone number will be lit. Secure these zones before […]

Why is my Napco Gem P801 system beeping?

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. SYSTEM TROUBLES The Control Panel is constantly monitoring its own components, as well as all critical services, such as AC power and the telephone line, to insure that it is always ready to provide the protection for which it was designed. When a […]