THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Entering Programming Mode A variety of system options can be programmed into your 5207 with Step Programming. Using the 5230 Remote Annunciator, you can enter Step Programming mode as follows: 1. Press the digits 2 7 . 2. Press ENTER . 3. Enter […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. Disabling/Enabling Zones When a zone is disabled, there is an alert tone that cannot be silenced until the zone is enabled. To either enable or disable: 1. Enter the zone number. 2. Press DISABLE . 3. Enter a valid operating code. The DISABLE […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. TROUBLE CONDITION The system alerting to a trouble condition could indicate a low system back up battery or zone sensor battery. Status codes: dc = Low Battery Ac = Low AC Power Silencing an Alarm or Trouble Warning In some situations, you may […]

THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM. TROUBLE CONDITION The trouble condition warning sounds when the control panel detects a malfunction in the 5207. It will issue a half-second beep every four seconds until the trouble has been silenced. It is important that your system be serviced as soon as […]