THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM.
To Bypass Zones:
Enter [*][1]; the “Bypass” light will FLASH.
Enter the number of the zone to be bypassed; the corresponding Zone Light will come ON to indicate that the zone is bypassed. To remove a bypass, enter the zone number to shut its Zone Light OFF. When all desired zones are bypassed, press the [#] Key to return to “Ready”. Notice that the “Bypass” light will be ON while the system is disarmed to indicate that zones have been bypassed.
When you arm your system, the zones you have indicated will now be bypassed. Before arming the system with bypassed zones, it is always a good idea to enter the [*][1][Access Code] command to review the list of bypassed zones before entering an Access Code to arm the system. After ensuring that the desired zones are bypassed, press the [#] Key, and then enter an Access Code to arm the system.
When the system is disarmed, the zone bypasses will be cleared and the zone will again be active.
To Recall Bypassed Zones:
Enter [*] [1] [9]; the “Bypass” light will FLASH and Zone Lights will come ON to indicate which zones were last bypassed. This feature is useful if you bypass the same set of zones regularly; by recalling the set of bypassed zones, you won’t have to enter the zone numbers for each zone each time you wish to bypass the same set.
Access Code Required for Bypass:
Your security system may be programmed to require an Access Code to be entered to bypass zones. Your installer will inform you if this option has been enabled on your system.
If an Access Code is required for bypassing, enter [*][1][Access Code], and follow the bypassing instructions described above.