THIS INFORMATION IS TAKEN DIRECTLY FROM THE MANUAL FOR THIS ALARM SYSTEM.
To assign, change, or delete user codes
1. Enter your Master code and press the CODE key.
2. Enter single-digit user number (‘2’, ‘3’, ‘4’, ‘5’, ‘6’ or ‘7’) for which a code is to be assigned, changed, or deleted.
3. If assigning or changing a user’s code, enter the desired 4-digit code for use by that user number. The keypad will beep once.
If deleting a user’s code, perform steps 1 & 2 and stop. In a few moments the keypad will beep once, indicating that the existing code has been deleted.
To assign your Duress code, do the following:
Enter your [Master code]+  +  + [desired 4-digit code]. The keypad will beep once.
The Master code can be changed by the main user of the system. To change it, do the following:
- Enter your [Master code]+  +  + [new Master code]+ [new Master code] again. The keypad will beep once.
Important:Temporary users should not be shown how to use any system function they do not need to know (e.g., bypassing protection zones).